[LESS INFO] 4 VIEWS | ADDED 11:54:12 05/21/09
This event took place at the Popular Woodworking offices in Cincinnati, Ohio, May 16 & 17.
The Schwarz Dances
1 Views 16:52:41 12/01/08
Christopher Schwarz, Editor of Popular Woodworking magazine, takes time out from his presentation on Forgotten Workbenches, to show us his new dance steps. Strut y...
[LESS INFO] 1 VIEWS | ADDED 21:52:41 12/01/08
Christopher Schwarz, Editor of Popular Woodworking magazine, takes time out from his presentation on Forgotten Workbenches, to show us his new dance steps. Strut your stuff, Chris!
#35. WIA - Scrapers...
2 Views 08:29:54 11/27/08
This is the rest of the session with Christopher Schwarz.
[LESS INFO] 0 VIEWS | ADDED 22:50:24 11/25/08
This episode continues the presentation by Christopher Schwarz at the Woodworking in America in Berea, KY.
#33. Scrapers: Hist...
3 Views 07:50:48 11/23/08
Chris Schwarz presents his research and results on sharpening card scrapers.
[LESS INFO] 0 VIEWS | ADDED 18:49:28 11/21/08
In this episode I share several photos I snapped during Woodworking in America 2008 and converted into an old-time movie.
#32. Bench planes w...
1 Views 19:43:10 11/20/08
In this episode, Deneb Puchalski covers the line of planes required to quickly flatten a board.
[LESS INFO] 0 VIEWS | ADDED 11:44:30 10/26/08
In this episdoe, Part 2 of the making of the prayer kneeler, I give some tips on the machining of the boards that make up the kneeler.
[LESS INFO] 0 VIEWS | ADDED 22:57:23 07/14/08
In this episdoe I answer Micharel's question: Is there a difference if you suntan cherry before or after applying the finish?
Episode 22. The Kre...
0 Views 19:26:17 06/17/08
In the last episode I showed how I fit the knife hinges to the door frames, and to the carcase.
In this episode I show how to create the overlapping rabbets, and...
[LESS INFO] 0 VIEWS | ADDED 23:26:17 06/17/08
In the last episode I showed how I fit the knife hinges to the door frames, and to the carcase.
In this episode I show how to create the overlapping rabbets, and adjust the width of the doors for eseentially zero gap.
Episode 21. The Kre...
0 Views 19:09:11 06/15/08
In this episode I show how I layed out the knife hinges, and the mortises in the doors and in the carcase. Then, for the first time, I do a dry fit of the frame an...
[LESS INFO] 0 VIEWS | ADDED 23:09:11 06/15/08
In this episode I show how I layed out the knife hinges, and the mortises in the doors and in the carcase. Then, for the first time, I do a dry fit of the frame and panel doors to the carcase.
Episode 20. The Kre...
0 Views 21:57:00 06/05/08
In this episode I show the making of the frame and panel doors, featuring spalted maple panels.
